Due to the large amount of orders being processed, some stock levels may occasionally not reflect actual stock levels due to differences in sale processing times. Please call to check availability to avoid disappointment.
With this wire you can drop the voltage by 0,7Volt for your Receiver or Servo.
Simply plug the wire in-between the current connection and done.
Technical Data:
Voltage: minus 0,7V
Wire female: JR / Futaba
Wire male: JR…
The UBEC uses a high-performance DC voltage regulator with switching module that draws its voltage from 3-14S LiPos. With it the regulator gives out 10A extremely stable or for a short amount of time 25A.Therefore this UBEC provides power for all kinds of RC modell devices. It is also suitable…
This UBEC is an external switching mode DC-DC regulator; it draws DC voltage from 2-3S LiPo battery, drops it to a voltage level that is suitable for your receivers and other electronic devices, and keeps providing the stable current output of up to 8Amp. As the UBEC has such a…
HOBBYWING V TAIL MIXER
This unit is for realizing the hybrid control of “Elevator” and “Aileron/Rudder”, it’s applicable for delta-wing aircraft, tailless aircraft (like Phantom & B2), and V-tail aircraft.
Spec Check:
Size: 31x8x8mm (LxWxH)
Weight: 4g(w/input wires)
Hybrid Control Rate: 1:1
Precision: 200 steps
…
Redesign every aspect
STM32 F405 MCU allows the FC to run the PID looptime and gyro with higher frequency.
Board load 12V BEC, the output current can reach 2A. It can supply power for graphic transmission, 12V LED lamp and other equipments.
The SPI ICM-20602 which integrates accelerometer and gyro…
Receiver Digital switch with 15A BEC current supply
Product features:
Using ultra high brightness led segment which can clearly be visible in the sunlight.
A set of electronic switch, input-output voltage display, 20AMP UBEC high current supply foryour receiver..
The three led segment displays real-time input and output voltage value, knowing the…
*Quick lid opening for easy access to transmitter
*A multi-functional foam is included for thinner transmitter. The foam can be used as sedan car stand as well.
*Integrated foam throughout to keep your gear protected
*Several pockets for all kinds of stuff, including mobile phones, key, etc.
*Good for most…
Features
The Signal Loss Alarm & Lost Aircraft Finder is controlled by a tiny MCU. As simple device, it can be plugged into any servo/RX port, will detect the loss of TX signal and emit a loud 85dB alarm. Ideal for warning you if you have not turned off your…
Multiplex parts are not normally held in stock, they are ordered as needed weekly from our Australian Distributor. If the Australia distributor is out of stock there will be a delay in sending your order.
If you need your item urgently please call to confirm availability…
Multiplex parts are not normally held in stock, they are ordered as needed weekly from our Australian Distributor. If the Australia distributor is out of stock there will be a delay in sending your order.
If you need your item urgently please call to confirm availability…
Product Information
These are the Phoenix Model Multi Connectors with 10 pins. The pack includes one male and one female plug. Designed for use to easily connect a multi servo wing to the fuselage. This 10 pin connector can easily accommodate 4 servos with individual signal leads and duplicates for power.…
Product Information
These are the Phoenix Model Multi Connectors with 6 pins. The pack includes one male and one female plug. Designed for use to easily connect a multi servo wing to the fuselage. This 6 pin connector can easily accommodate 2 servos with individual signal leads and duplicates for power,…