Features
- 8mm Stainless-Steel Motor Shaft
- Stainless-Steel Sleeve
- Silicone Coated 8-Gauge Copper Wire
Product Information
Ideal for running up to 8s LiPo in 1:8 and 1:7 scale vehicles, the mechanical design boasts a stainless-steel sleeve to reinforce and strengthen the rotor for high RPM operation. Coupled with a massive 8mm stainless steel motor shaft, 8.0mm bullets and high strand, low resistance, silicone-coated 8 gauge copper wire, the 1721-2400Kv will deliver massive power and maximum top-end speed.
WARNING: Drag and speed run setups are inherently abusive and extremely hard on all electronic components. Every component in the configuration can be strained, weakened (or worse) without using extreme caution, observance of electric theory and advanced knowledge of all aspects of the RC hobby. High-speed runs and drag racing are the most advanced, aggressive and volatile applications in the RC car hobby. Improper setup or use of this product can result in catastrophic failures of the motor, ESC and/or batteries. We’ve outlined important product use information below; following these guidelines will significantly reduce failures and increase your happiness and excitement. If you have any questions, just give us a call; we have real people right here in the USA ready to help you get the most (as safely as possible) from your setup.
What you need
- Compatible Electronic Speed Control (ESC)
Specs
Number of Poles 4
Forward Yes
Reverse Yes
Motor Size 1721
Application 8s Lipo in 1/8 and 1/7 scale vehicles
Connector Type 8mm Bullet
Recommended Speed Control Castle Mamaba XLX2 ESC
Product Length 3.99" (101 mm)
Input Voltage Min: 4s LiPo Max: 8s LiPo (33.6V)
Outer Diameter 1.87" (47 mm)
Shaft Diameter 0.31" (8 mm)
Shaft Length 0.86" (22 mm)
Product Weight 816.4g (28.8oz)
RPM/Volt (Kv) 90,000R RPM / 2400Kv
